Tumbler wrap
A short band for a 20 oz tumbler: a greeting across the middle and a little holly at each end.
- Difficulty
- Patient
- Time
- About 40 minutes
- Size
- 9.25 × 3.5 in
Materials
- A straight-sided 20 oz tumbler, or our insulated tumbler
- Permanent adhesive vinyl, or a printed wrap from a shop
- Measuring tape, squeegee, and a sharp knife
- The studio band starts at 9.25 × 3.5 inches — measure your blank and change the artboard if it differs
Steps
- Measure the tumbler. Height of the printable wall, and the circumference, minus a small gap so the ends do not overlap on the seam.
- Set the artboard to that size. This project starts at 9.25 inches wide by 3.5 inches tall.
- Edit the greeting. Keep it on one line so it does not climb onto the lid or the base.
- Export an SVG for vinyl, or a PNG at 300 DPI for a printed wrap. The PNG background is transparent.
- Cut or print, then line the band up with the seam of the tumbler. Squeegee from the center toward the ends.
- To order the insulated tumbler instead, use Put this on a product. The shop prints the design; you do not cut vinyl.
Tips
- Tapered tumblers need a curved template. This band is for a straight wall. If the cup narrows, cut the vinyl a little short and do not force it.
- Leave a quarter inch unprinted at the seam so the join does not show a double edge.
- Dark vinyl on a light cup is easier to weed than a full-coverage print.